HalfAutomatic Pneumatic Pipe Cutting And Beveling Tools For On-site Construction

HalfAutomatic Pneumatic Pipe Cutting And Beveling Tools For On-site Construction

Product Introduction

The Split Frame machines is ideal for all types of pipe cutting,beveling and end prepping.Our precise,consisteently square cuts and bevels on pipe and tube and casing the first time,every time.SFM series machines are widely used in nuclear power, thermal power, petroleum, chemical plant, natural gas, boiler plant, pharmaceutical factory and other areas.

Specifications

Bevel Type

We have standard beveling tools of 5°,10°,20°,30°,37° and also can customize the tools.

We have several bevel type: v-shaped, y-shaped, compound shaped, compound j-shaped as well as j-shaped. Customized tools can be provided for processing bevels of other angles.

Standard Configuration

We have standard configuration for the shipped machine. In addition to packaged SFM machine, we will give you relevant motor, cutting and beveling tools according to your drive mode and choice. We will have a set of tools to help use the machine such as rubber hammer, spray bottle, square and wrench set. Moreover we will have relevant documents to support you such as operating manual, certificate of conformity and u-disk. If you have other demands, we will try to meet your demands.

Storage

■ Clean the dust, debris and accumulated oil or grease on the machine;

■ Inject some lubricating oil to the oil injection hole of the machine, and run the motor for some time to lubricate internal components;

■ Paint or apply a thin layer of anti-corrosion lubricating oil on surfaces that have not be completed or painted;

■ Store the machine in a storage case, and put all components in corresponding compartments;

■ The storage case shall be stored indoors as far as possible and kept dry.

pneumatic pipe cutting beveling machine

pneumatic cold cutting machine

HalfAutomatic Pneumatic Pipe Cutting And Beveling Tools For On-site Construction Images